Ford Mustang Boss 302 1/16
Aluminum caps, pivot ball (threaded aluminum, hard-anodized with Teflon coating) (8)/ hex wrench, 5mm
1 in stock (can be backordered)
Antenna, tube, blue (1)/ vinyl antenna cap (1)/ wire retainer (1)
8 in stock (can be backordered)
Ball bearings, blue rubber sealed (4x7x2.5mm) (2)
4 in stock (can be backordered)
Ball bearings, blue rubber sealed (5x8x2.5mm) (2)
6 in stock (can be backordered)
Ball bearings, blue rubber sealed (8x12x3.5mm) (2)
3 in stock (can be backordered)
Battery, Series 1 Power Cell (NiMH, 2/3A stick, 7.2V)
4 in stock (can be backordered)
Body mount, rear/ body mount posts, front (2)/ body washer, rear (2) (for Mustang body)
Available on backorder
Body mount, rear/ body mount posts, front (2)/body washer, rear (2) (for Fiesta/Rally body)
2 in stock (can be backordered)
Body mounts, front & rear/ body mount posts, front & rear
2 in stock (can be backordered)
Body, GTR shock (hard-anodized, Teflon-coated aluminum) (1)
Available on backorder
Body, Rally (clear, requires painting)/ grill and lights decal sheet
Available on backorder
Box, receiver (sealed)/ wire cover/ foam pads, upper & lower/ silicone grease/ 2.5×8 CS (4)/ 3×4 GS (1)
Available on backorder
Bulkhead tie bars, front & rear (blue-anodized aluminum)/ 2.5×6 CS (1)
1 in stock (can be backordered)
Bulkhead, front (left & right halves)/ 3x10MM BCS (4)
2 in stock (can be backordered)
Bulkhead, rear (left & right halves)/ 3x10MM BCS (4)
2 in stock (can be backordered)
Caps and spring retainers, GTR shock (upper cap (2)/ hollow balls (4)/ bottom cap (2)/ upper retainer (2)/ lower retainer (2))
2 in stock (can be backordered)
Cover plates, differential (front or rear)/ gaskets (2)/ o-rings (2)/ 2x14mm BCS (4)
1 in stock (can be backordered)
Cover, gear/ motor mount hinge post/ 3x10mm CS with split and flat washers (1)/ 3x8mm BCS (1)
1 in stock (can be backordered)
Differential kit, center (complete for 1/16 E-Revo, 1/16 Slash)
1 in stock (can be backordered)
Door, battery compartment (1)/ vents, battery compartment (1 pair) (fits right or left side)
2 in stock (can be backordered)
Drive cups, inner (2) (steel constant-velocity driveshafts)
Available on backorder
Driveshaft assembly (1) left or right (fully assembled, ready to install)/ 3x10mm screw pin (1)
1 in stock (can be backordered)