After Run oil 50ml

7,59 

1 in stock

SKU: OP101909K Categories: ,
Description

This is a bottle of after-run oil suitable for all internal combustion engines (mostly run on methanol/nitro based fuels).

The oil also works good as an engine assemble oil.

Directions:

  1. After a day of running the engine – empty the fuel tank of most of it’s fuel. Leave enough fuel for the engine to be able to run a couple of minutes at idle speed.
  2. Start the engine, let it idle and reach working temp and let it idle until the remaining fuel in the tank is empty, as in the engine stops by itself.
  3. Try starting the engine again until you are sure that there is no more fuel in the tank/fuel lines or the engine itself.
  4. Remove the glow plug and remove any air filter system.
  5. Add a few drops of OptiFuel after-run oil through the glow plug hole and the carburettor opening.
  6. Spin the engine carefully/slowly a few times to spread the oil inside the engine and bearings.
  7. Inspect the glow plug and check it’s condition – replace if needed.
  8. Re-install the glow plug.
  9. If your engine has an air filter system (car engines) – clean it and/or replace it. If it’s a “wet oil” filter – re-apply the foam with a special air filter oil.
  10. Re-install the air filter.
Additional information
Weight 0,932 kg