E-Revo 1/16
1/16th Scale Axle Carriers for the Traxxas e-Revo, Slash, Summit & Rally
2 laos
Aluminum caps, pivot ball (threaded aluminum, hard-anodized with Teflon coating) (8)/ hex wrench, 5mm
1 laos (saab järeltellida)
Antenna, tube, blue (1)/ vinyl antenna cap (1)/ wire retainer (1)
8 laos (saab järeltellida)
Ball bearings, blue rubber sealed (4x7x2.5mm) (2)
4 laos (saab järeltellida)
Ball bearings, blue rubber sealed (4x8x3mm) (2)
4 laos (saab järeltellida)
Ball bearings, blue rubber sealed (5x8x2.5mm) (2)
6 laos (saab järeltellida)
Ball bearings, blue rubber sealed (8x12x3.5mm) (2)
5 laos (saab järeltellida)
Battery, Series 1 Power Cell (NiMH, 2/3A stick, 7.2V)
Saadaval järeltellimisel
Body mounts, front & rear/ body mount posts, front & rear
2 laos (saab järeltellida)
Body, 1/16 E-Revo (clear, requires painting)/ grill and lights decal sheet
Saadaval järeltellimisel
Body, GTR shock (hard-anodized, Teflon-coated aluminum) (1)
Saadaval järeltellimisel
Box, receiver (sealed)/ wire cover/ foam pads, upper & lower/ silicone grease/ 2.5×8 CS (4)/ 3×4 GS (1)
Saadaval järeltellimisel
Bulkhead tie bars, front & rear (blue-anodized aluminum)/ 2.5×6 CS (1)
1 laos (saab järeltellida)
Bulkhead, front (left & right halves)/ 3x10MM BCS (4)
2 laos (saab järeltellida)
Bulkhead, rear (left & right halves)/ 3x10MM BCS (4)
2 laos (saab järeltellida)
Caps and spring retainers, GTR shock (upper cap (2)/ hollow balls (4)/ bottom cap (2)/ upper retainer (2)/ lower retainer (2))
2 laos (saab järeltellida)
Connector, power tap (with voltage sensor plug)/ wire tie/ 2.6×8 BCS (2)
1 laos (saab järeltellida)
Cover plates, differential (front or rear)/ gaskets (2)/ o-rings (2)/ 2x14mm BCS (4)
1 laos (saab järeltellida)
Cover, gear/ motor mount hinge post/ 3x10mm CS with split and flat washers (1)/ 3x8mm BCS (1)
1 laos (saab järeltellida)
Differential kit, center (complete for 1/16 E-Revo, 1/16 Slash)
1 laos (saab järeltellida)
Door, battery compartment (1)/ vents, battery compartment (1 pair) (fits right or left side)
2 laos (saab järeltellida)
Drive cups, inner (2) (steel constant-velocity driveshafts)
Saadaval järeltellimisel
Driveshaft assembly (1) left or right (fully assembled, ready to install)/ 3x10mm screw pin (1)
2 laos (saab järeltellida)
Driveshaft, 1/16 E-Revo (steel constant-velocity) (assembled) (4)
Saadaval järeltellimisel
Driveshaft, steel constant-velocity, 1/16 E-Revo (shaft only, 68mm)/ drive cup pin (1)
Saadaval järeltellimisel
Duffel bag, medium, 760 x 300 x 300mm (fits 1/10 Slash®, TRX-4®, & similar)
1 laos (saab järeltellida)
Gear set, differential (output gears (2)/ spider gears (3))/ differential output shafts (2)/ 1.5x6mm pin (3)/ 1.5x8mm pin (2)
2 laos (saab järeltellida)
Gear set, metal (for 2080R waterproof micro servo)
1 laos (saab järeltellida)
Gear set, metal (for 2080X micro waterproof servo)
2 laos (saab järeltellida)
Gear set, transmission (includes 18T, 25T input gears, 13T idler gear (steel), 35T output gear, M3x13.75 screw pin)
1 laos (saab järeltellida)