Futaba S-CD500KS Knuckle-Servo Drifting 2.4kg 0.13s

Introducing the “knuckle servo,” which breaks the conventional wisdom of steering structures in RC cars. Unleash new possibilities on your beloved car.

• The S-CD500KS is a servo compatible with “UR mode” and “SR mode”.
• To use this product, you will need one of the upgraded versions of your T10PX, T10PXR, T10XCR, or T6PV radio, in addition to the GYD560 gyro.

Features:

• No tie rods, therefore no bump changes.
• Lightweight design is possible because mechanical linkage parts are not required.
• Ackermann adjustment and other settings can be changed wirelessly from a compatible transmitter.
• Steering toe angle can be mixed via the trigger of the compatible transmitter.
• Smooth operation even at large steering angles

Specs:

• Size: 32.0 x 16.6 x 27.6 mm
• Weight: 20.7 g
• Speed: 0.130 sec/60° (6.0V) / 0.165 sec / 60° (4.8V)
• Torque: 2.4 kg/cm (6.0V) / 2.0 kg/cm (4.8V)
• Operating voltage: 4.8V to 6.0V
• Lead wire length: 330mm
• This servo is a steering servo for 1/10 scale electric 2WD drift cars.

*Two servos are required for each vehicle.

Software Notes:

• The GYD560 requires a software update to version 2.0 or later.
• Software updates are required for T10PX(R) and T10XCR to Ver. 16.0 or later, and for T6PV to Ver. 4.0 or later.

Notes:

• The transmitter needs a function to mix two steering servos.
• Please use the ESC’s BEC output at 6.0V. Using the BEC output at 7.4V may cause damage.
• A humming sound may be heard when the power is turned on, but this is not a malfunction.

Connection Method

*Please install the wiring so that it does not come into contact with the wheel.

If the wiring is broken, it may become inoperable or short-circuit, causing damage.

Accessories (for the 2-piece set)

• Upper rod end x 2 (4 pieces)
• Axle shaft x 1 (2)
• Spacer x 1 (2)
• M2 nut x 1 (2 pieces)
• M2 screw x 1 (2 pieces)

*Wheel hubs, wheel hub fixing pins, and bearings (10mm outer diameter x 5mm inner diameter, 4mm thickness) are not included and must be purchased separately.

Additionally, two bearings are required for each servo (four bearings if there are left and right servos).