Maxx Slash
Varuosade sobivus on koostatud mudeli Traxxas Maxx® Slash® (102076-4) varuosade nimekirja (REV. 250310 0459) põhjal automaatselt. Oleme andnud endast parima, et esitatud varuosade sobivus oleks täpne. Siiski palume kontrollida varuosade sobivust mudeliga kaasas olnud varuosade nimekirjast või joonistelt. Kui jääd hätta või ei ole varuosa sobivuses kindel, võta meiega ühendust!
Adapter, standard servo (adapts standard servo to fit in X-Maxx® or Maxx®)
1 laos (saab järeltellida)
Adapter, Traxxas® iD® LiPo battery (adapts Traxxas iD batteries to separate balance ports)
1 laos (saab järeltellida)
Antenna, tube, black (1)/ vinyl antenna cap (1)/ wire retainer (1)
4 laos (saab järeltellida)
Antenna, tube, blue (1)/ vinyl antenna cap (1)/ wire retainer (1)
7 laos (saab järeltellida)
Attachment screws, shock (3x12mm shoulder screws) (6)
2 laos (saab järeltellida)
Backplate screws (3x8mm cap-head machine) (6)/washers (6)/ wrench
2 laos (saab järeltellida)
Ball bearings, blue rubber sealed (8x12x3.5mm) (2)
6 laos (saab järeltellida)
Battery charge indicators (green (4), blue (4), grey (4))
2 laos (saab järeltellida)
Battery door, transmitter (replacement for #6516, 6517, 6528, 6529, 6530 transmitters)
1 laos (saab järeltellida)
Carrier, differential/ x-ring gasket/ o-ring (2)/ 10×19.5×0.5 TW
1 laos (saab järeltellida)
Connector, 25.2 volt to 14.8 volt jumper (allows a Traxxas® dual-battery 25.2 ESC to run on a single 14.8V battery pack)
3 laos (saab järeltellida)
Differential kit, center (complete) (aluminum carrier, 100K wt differential fluid) (fits Maxx® or Maxx® Slash®)
1 laos (saab järeltellida)
Differential oil kit (1 each: 10K, 30K, 50K weights)
2 laos (saab järeltellida)
Differential output yoke assembly, front or rear (assembled with external-splined half shaft)
1 laos (saab järeltellida)
Drive cup (1)/ 4×15.8mm screw pin (for use only with #8950X, 8950A driveshaft)
1 laos (saab järeltellida)
Gear set, differential (output gears (2)/ spider gears (4)/ spider gear shaft (2)/ output shaft (2)/ 2.5X13.8 pin (2))
1 laos (saab järeltellida)
Gear, 15-T pinion (1.0 metric pitch) (fits 5mm shaft)/ set screw (for use only with steel spur gears)
4 laos (saab järeltellida)
Gear, 16-T pinion (1.0 metric pitch) (fits 5mm shaft)/ set screw (for use only with steel spur gears)
2 laos (saab järeltellida)
Gear, 17-T pinion (1.0 metric pitch) (fits 5mm shaft)/ set screw (for use only with steel spur gears)
2 laos (saab järeltellida)
Gear, 18-T pinion (1.0 metric pitch) (fits 5mm shaft)/ set screw (for use only with steel spur gears)
2 laos (saab järeltellida)
Gear, 18-T pinion (machined) (1.0 metric pitch) (fits 5mm shaft)/ set screw (for use only with steel spur gears)
2 laos (saab järeltellida)